Kisan-electronics CG-10 User Manual

Page - 8 TEMPERATURE SENSOR Typical location of the temperature sensor should be close to the road surface. Do not locate it near the exhaust or

Page - 9 INSTALLATION Route the cable and make sure that the cable does not rub against any sharp edge or can pinch tightly between panels. Do not p

Page - 10 chargeX CX-10 RJ11 port is for future use only. chargeX is an onboard charger. It is design

Page - 11 INSTALLATION For those motorcycles, where the battery is under the seat, and inside an enclosure, you may have to mount it along the rail

Page - 12 LED STATUS INDICATOR g aUngrounded AC outlets, condensation near the outlet or on the floor, or an overload from another appliance on th

Page - 13 chargeX -mini CXM-20 This wall-mount charger utilizes switch-mode technology for compact size. It has multi-step char

Page - 14 CHARGING CYCLES IOUT (MAX)VOUT (NOM)Standby Mode Battery not connected 0 Amp 0 Volts Constant Current Mode Fast Charge Cycle 1.1 Amp 14.

Page - 15 FAQs: Q: I have installed the chargeX on my bike but the location is such that I cannot see the status LED. Can I extend the wires for th

Page - 16 Q: I have noticed that the 3-flash GFIC warning is indicated by the chargeX every once in a while, even though my garage outlet is protec

TABLE OF CONTENTS CGF-10 chargeGUARD – Multi-function Display - Installation tips - Mode Selections Faceplate removal procedure 23 4 5 CGS-10 C

Page - 2 DISPLAY chargeGUARD multi-function display can be flush mounted or attached to the handlebar. z Auto-start feature - any activity of the

Page - 3 DISPLAY INSTALLATION f For best viewing, the Display should be vertical – not lay flat f Display location depends on the cable length – to

Page - 4 MODE SELECTIONS chargeGUARD display has a single button scroll feature to allow easy mode change while you are riding - even with gloves o

Page - 5 DISPLAY FACEPLATE chargeGUARD Display has a detachable faceplate. It can be painted to match your dash color, or additional faceplates in

Page - 6 CURRENT SENSOR The Current Sensor is an Integrated Copper Shunt, which mounts on the NEGATIVE (Ground) battery post.  Shunt is rated fo

Page - 7 INSTALLATION COPPER PLATE BENT 90º Note! Copper plate should only be bent along the two notches. DO NOT pull on the wires while bendi